[ICA-W3250V] How to hard-reset the ICA-W3250V to factory default values.

Please follow the steps below:

1. Remove the power and Ethernet cable.
   
2. Take an electronic wire and plug one side of the wire into "Default" and the other side into "GND" on the terminal block as the picture is shown below.


3. Connect power to the camera again. It takes around 30 seconds to boot the camera.
   
4. Remove the wire and plug it into the Ethernet cable after the camera finishes booting.
   
5. Re-login the camera via the default IP (http://192.168.0.20). The user name and password are admin.