FAQs

Please follow the steps below ：
1)Default Gateway and DNS server address should be set up correctly.
2)If FTP does not work properly, ask your ISP or network administrator about the transferring mode of FTP server

The heater of the ICA-2250VT will be turned on when the maximum power consumption reaches 19.8W.

The DVC family products, DVC-400, DVC-800, DVC-400C can work with the P4 or above PC directly.
The PC board list below shows the tested main board listing, VGA listing and the hardware requirements.

1. Approval Motherboard List

2. Minimum Hardware Requirements:

3. Network Interface Chip
Realtek 8139C, 8100B
Kinnerreth-R
Intel 82562EZ
Marvell 8001
Intel 82547EI

4. ATA Extension Card
Promise Ultra 100 TX2
Promise Ultra 133 TX2
HighPoint Rocket 133

5. SCSI Card Adaptec 29160, 39160
Tekram: DC-390U, DC-390U2D, DC-390U2B, DC-390U2WE, DC390
ACARD

6. RAID0/1 support
ACS 7500

7. RAID0/5 support
ACS 7630

8. DVD Burner

Please installed Microsoft®’s DirectX 9.0 or later and uses the Windows Media Player 11.0 or later to play the AVI filed recorded by the Device.

Please installed Microsoft®’s DirectX 9.0 or later and uses the Windows Media Player 11.0 or later to play the AVI filed recorded by the Device.

Username: admin, password: admin.
Note that it’s all case-sensitive.

1. The digital recording system is very sensitive. It can detect the tiniest motion that human eyes cannot perceive. You can lower the sensitivity setting in camera setup menu.

2. Flickering fluorescent lights (when traditional 120 Hz ballast are used) or TV (or computer) screen can be the motion source. In this case, adjust the motion detection area so that these flicking sources will not be detected. It is recommended not to align the camera directly at fluorescent lights, TV, or computer screens. The use of better-quality fluorescent lights (with electronic ballast), monitors, and the cameras can be considered.

3. When cameras are installed, please make sure the quality of cables, connections, and workmanship. Sometimes interference could cause the image unstable. Avoid placing the system close to a compressor (fridge), or to a motor (washing machine) that might cause magnetic interference.