[VR-100/IVR-100] How to configure the IPsec VPN between VPN Routers

Follow the steps below for setting up the routers:

1. Go to the VPN -> IPsec page.
2. Set the IPsec Tunnels as enable.
3. Click Add IPsec Tunnel button .
   
   
   
4. Set the Active as enable.
5. Input the Tunnel Name and select <b>Interface</b>. 
6. Input the Local Network and Netmask as the router’s LAN IP address.
7. Input the Remote Host/IP Address as another router’s public WAN IP address.
8. Input the Remote Network and Netmask as another router’s LAN IP address.
9. Input the Preshare Key as the same as the one set on both routers.
10. Set the IKE Setting. It should be the same as the other router.
11. Click Apply Settings button to save changes.
    

VPN Connection Status

There are two ways to check the VPN connection status.

1. Go to the VPN -> IPsec page. The status shows Connected.
   
2. Go to the VPN -> VPN Connection -> IPsec page.