Please follow the steps below to set up the NTP feature of the IGS-6325 series:
1. Enable the NTP configuration mode.
2. Configure the correct time zone.
3. Configure the DNS Server and make sure the switch can access the internet.
4. Finally, you can get the correct system time.
Here are the steps:
1. By default, the IGS-801M supports 10K Jumbo Frame. Please follow the path to check it: Switching→Jumbo Frame.
2. Please go to the DoS Global Setting by following the path: Security→DoS Global Setting.
Please disable the ICMP Fragments and UDP Blat, and your device may communicate with the IGS-801M.
Application:
Configure the ACL so that the 192.168.10.1 device can only be accessed from the 192.168.10.10 device.
Free data transfer was allowed between 192.168.10.1, 192.168.10.2, 192.168.10.3 and 192.168.10.4.
Access to devices 192.168.10.2, 192.168.10.3 and 192.168.10.4 from device 192.168.10.10 should be denied.
Topology:
ACL Configuration
1. Add an ACL name in an IPv4-Based ACL, such as “test”.
2. Set the ACL Name, Sequence, Action, Source IP address and Destination IP address parameters in the IPv4-based ACE.
3. ACL rules needed in the IPv4-based ACE Table for the application.
4. At last, set the ACL Binding and select the required ports.
Topology
Note: PPTP may not pass through NAT.
ICG-2420 Setting
4G Mobile Phone Setting
1 2
3 4
The IP address must be the public IP address and ensure the network is connected via internet.
For example: The domain name is jerryp.planetdds.com.
The public IP address is 210.66.155.86.
Step 1
Apply an account on www.PLANETDDNS.com , and new domain name on the website.
Step 2
Enable DDNS configuration.
Step 3
Check the status of PLANET DDNS on the website.
Step 4
Enable the firewall as shown below.
#Rule 1
#Rule 2
If you use a private IP address via the 4G-LTE internet, PLANET DDNS will not work.
As this is the private IP address, and the PLANET DDNS address will not work, and thus the ping status will show in red, but the connected IP still shows.
Conclusion:
If you want to use 4G internet with PLANET DDNS working, please apply for a 4G-SIM card which has a public IP address from 4G ISP provider.
[IGS-6325-24P4S]As we know, both Cisco and HP SFP module’s built-in block code that limits to user only can install the Cisco and HP SFP Mini-GBIC module into Cisco and HP switch. It is recommended to select an SFP module without block code, such as PLANET or third-party SFP module.
[IGS-6325-24P4X]As we know, both Cisco and HP SFP module’s built-in block code that limits to user only can install the Cisco and HP SFP Mini-GBIC module into Cisco and HP switch. It is recommended to select an SFP module without block code, such as PLANET or third-party SFP module.